Installing the safety is also quite straight forward.

Before putting the Safety into the trigger housing, grease the rear part of it where it will slide against the trigger housing. This of course provides lubrication and rust resistance. Note the post on the safety in the photograph above. This post is put into the hole in left side of the trigger housing.

Once the rear portion of the Safety has been lubricated it is a simple matter to slide it into the rectangular hole at the bottom of the trigger housing. Note that the little point 1/3 of the way from the bottom of the safety does not go outside of the trigger housing.

The final step in assembling the Safety is simply to snap it into it's final position. In order to do this depress the clip latch spring slightly and then move the Safety into position so that the post on its left side snaps into the hole on the trigger housing.

Once the safety is secure turn your attention toward the Hammer.

Next Page